Before Starting to Use
Preparing to Print
22
Setting up the Paper Receiving Tray
1 Open the Paper Receiving Tray.
Pull the Paper Receiving Tray down until it comes
to a rest.
2 Position the Receiving Tray Paper
Guides.
1) Raise the Receiving Tray Paper Guides.
2) Hold their lower part and slide them to fit the
paper width.
Important!:
• For thick paper such as drawing paper, position
the Receiving Tray Paper Guides a little wider
than the actual paper width.
• When you move the Paper Feed Tray using the
Horizontal Print Position Adjustment Dial, repo-
sition also the Receiving Tray Paper Guides. If
the guides are not correctly positioned, a prob-
lem such as a paper jam can occur.
3 Set the Paper Stopper.
1) Raise the Paper Stopper.
2) Slide to fit the length of the paper.
The subsequent steps differ depending on the
models.
• For EZ3XX, go to step 4.
• For EZ2XX, go to step 6.
4 Adjust the Paper Arrangers.
(For EZ3XX only)
Alignment of paper is affected by sizes and
strength of paper. Adjust the Paper Arrangers so
that printed paper is aligned.
z For plain paper
Press to open all of the four Paper Arrangers.
REG-LL_EN.book Page 22 Wednesday, September 14, 2011 12:03 PM
Comments to this Manuals